REDLAND Dental GliderMax High Speed Handpiece Non-LED (6x)

Consists of  6x handpiece head. handle. caudal thread, cartridge.

1. Air pressure 0.25-0.30MPa, must be filtrated.
2. Use high speed dental bur with shaft dimension (b 1.59—1.60mm and roughness less than 0.8 u m.
3. The amount of handpieces’ spray or water spray should be able to adjusted.

Specifications:

1. Haid glass figer can be  repeatedly sterilized in high temperature and pressure.
2. Operate the handpiece at pressures of 25 to 30 psi. Engineered to attain speeds of 300,000 at 25 psi and 400,000 at 30 psi.
3. Clamping force of handpiece is: 20-45N

Only used for drilling, molar of stomatology clamping high-speed dental burs.

WARNING

1. Considering safety first, please be careful to use it with full attention.
2. Be limited to dentists who held the dental treatment qualifications
3. Slease bid detestosition aside of stricts oral befor feel anomalies, please stop using
4. Please run point testing on outside of patients’ oral beforehand. immediately and contact with our after-sales center
5. When appears abnormal during using, please stop it immediately and contact with our after-sales center.
6. It will cause a high noise using a center-vibration or bended bur and a handpiece of which bearing has been worn. A long time in this state will be harm to people’s hearing. Forbid using a vibration or bended bur, if appear high noise, please replace the shaft core in early.
7. Do not use a bending, cracking, deformation and unqualityfy bur. Ifusing it, may cause a snap, or a flying off to injury accident during operation process.
8. Please ensure the bur chuck be clean. If with contaminant inside of it, may causes bur clamping weaken or shaft core vibration.
9. Please run the bur under the provision rotation -speed by bur manufacturers
10. Do not crash, especially to avoid falling..
11. Please installa bur ora standard stick before using.
12. Aslo remember to install a bur or a standard stick when not in using.
13. Please unload the bur and handpiece when the running stopped in completely